Petit Maison: Part I

Day 1: House after a few hours of prep and a trip to the craft store

I like the idea of making things, this is one of the things architects do all day, the work involved in actually designing, sketching, cutting and assembling an object from scratch is fun for me so I decided to make a small play house for Arielle. Initially, she really wanted one large enough for her and her cousins to hide out in but there isn't anyway I can do that so we decided to make one large enough for her dolls. I am not really interested in making a dollhouse in the traditional sense of the word and I certainly don't have the time to do so either but I can handle a simple design so thats what I sketched up; A simple two story house with a pitched roof. It is very hard for me to keep it simple and not go into real design mode, start sizing beams and calculation stair risers! 

   

Anyway, we started by going to the craft store to buy supplies. I decided to base the house on the largest piece of birch plywood I could find in the store which turned out to be 12"x24"x1/8". Here's what we bought: (2) -12"x24"x1/8" birch plywood, (10) -4"x24"x1/8" basswood, (4) -4"x24"x3/32" basswood and a mix of miscellaneous wood dowels. I also got out my X-acto knife, blades, Sobo glue, architectural scale, pencils, chopper, cutting mat and metal ruler. 

After a quick sketch to figure out what rooms we wanted, we started building.

Because the birch plywood is so hard, I used 1/8" basswood strips for the exterior walls laminated to museum board. The was good for two reason; it gave the wall thickness ( stability) and made it so that I could have a wood finish on one side and white on the other. Arielle enjoyed covering the entire 22x30" board with glue. We then laid each sheet of basswood carefully onto the board and piled magazines atop to keep it flat while it dried. We did this twice, one sheet for the front and back walls and then another for the long side wall.

While that was drying, I measured and cut 4 dowels to use as the edges for the floor slabs. I cut (4) 24" pieces and (4) 12" peices-less the thickness of the dowels. I then glues these onto the bottome of the (2) 12"x24"x1/8" birch plywood sheets and set those aside to dry.

Once the laminated wood and museum boards were dry, I drew out the profiles for the front and back sides and the side and began to cut them out using the x-acto knife and a metal ruler.

As I finished cutting them out I decided to try to assmeble the house to see if things fit together properly. Its important to do this before you glue anything together so you can adjust and trim where needed. If I was using a laser cutter, I wouldn't worry but because I am manually cutting this out by hand, I need to make things line up properly. I did this by basically using anything I could find to hold the walls up with and masking tape.

Two picture frames are holding up the second floor and I taped the walls together at the corners.

It took me a few hours to do all this only because I had a 3 year old helper and a 6 week old strapped to me in a Moby wrap but really its a quick process from start to finish. The next step will be to design and cut out the fenestration and interior walls.

After doing this, we took another trip to the craft store to get more board and pick out wall paper to decorate the house with. Arielle picked out this Dalmatian figure and the lady at the checkout forgot to ring it up until after I had paid up. I promised we'd be back to get it another time but a young lady behind us actually asked her to ring it up with her stuff and gave it to Arie...I had no idea people like this still existed..but it really made Aries day! So now we have a pet for our house.

Next Post: Fenestration and interior walls....